Auto Glass Columbus
Windshield Repair Columbus
Windshield Replacement Columbus
Steps Involved in the Process of Windshield Repair
16:04 |
| Windshield Repair Columbus |
Driving a car with a damaged
windshield is nothing but a risk that no driver should ever take. Instead of
driving the car in this condition, every sensible driver must take the vehicle
to the nearest auto body shop to avail the best service in windshield repair in Columbus. These shops often have the services of expert technicians who can put
their best services to mend the damage.
However, the decision of
windshield repair or replacement depends on the severity of the damage. The technicians use their special techniques
to decide the best treatment for the damaged windshield. The minor damages or
cracks are often repaired. The process of repairing is very technical where the
technicians need to follow every single step with great care.
Following
are the steps involved in the best service of windshield repair in Columbus:
- Technicians clean and clear the windshield’s surface to get a better view of the crack or damage.
- They remove all the broken pieces with great care using a razor blade. They clean the surface with a window or windshield cleaner and allow it to dry up completely.
- The technicians use the suction tool directly over the damaged area on the windshield. The tool has four suction cups that are connected to the x-frame. With ultimate care, they insert the cups inside the glass adjusting the position of the hole in x-frame.
- They use a plastic tube here that is a hollow from inside. They put this tube in the hole of the suction cup. They fix the tube in the hole tightly so that it does not get unfixed easily later on. They need to ensure that the tip of the tube faces the top of the broken or damaged glass.
- They, then, set the resin in the plastic tube very carefully. While doing so, they ensure the cap of the tube remains open.
- After this, they allow drops of resin to flow inside the tube and ultimately to the damage or crack on the windshield.
- They remove the whole kit from its position and allow the resin to settle down completely.
- They even out the accumulated resin by spreading it out over the small damages. They remove the extra resin using the razor blade again.
- In the end, they allow the resin and the glue dry out completely. It takes some time to dry out. The technicians never allow the drivers or owners to drive away till the glue and resin are dried out completely.
These steps are carried out with great care. The
technicians never take any risk in the steps mentioned above as it would create
potential risks to the users in the end.
0 comments